Toyota Corolla

1992-1998 of release

Repair and operation of the car



Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
- 12. Electric equipment
   12.1. Safety locks
   12.2. The burned-through crossing points
   12.3. Automatic switches
   12.4. Relay
   12.5. Breakers of indexes of turns / alarm system
   12.6. The combined switch
   12.7. The switches installed on a steering column
   12.8. Lock of ignition and drum of the lock
   12.9. Switch of a heater of back glass
   12.10. Heater of back glass
   12.11. Radio receiver and loudspeakers
   12.12. Antenna
   12.13. Bulbs of headlights of head light
   12.14. Headlights of head light
   12.15. Replacement of bulbs
   12.16. System of day inclusion of headlights
   12.17. Engine of screen wipers
   12.18. Instrument guard
   12.19. Sound signal
   12.20. System cruise control
   12.21. System of the central lock
   12.22. System of window regulators
   12.23. Rear-view mirrors with the electric drive
   12.24. Safety airbag
   + 12.25. Electroschemes


12.22. System of window regulators

GENERAL INFORMATION

Arrangement of elements of system of window regulators

1. Engines of window regulators
2. Ignition lock
3. Window regulator engine
4. Block of safety locks of N1 (Safety lock of window regulators)
5. Main block of switches
6. Switches of window regulators

The system of window regulators is based on work of the electric motors established in the doorway which lift and lower glasses. The system of window regulators consists of switches, engines (regulators), glasses and connecting wires.

Regulators of glasses are connected so that glasses can be lowered or lifted by means of the main block of switches at the driver or by means of the switches located directly on doors. On each door the separate motor which can work in both directions is installed, lifting and lowering glasses.

Position of the switch defines polarity and, thus, the engine area of work. On some models the relays controlling the electric current arriving on engines of window regulators are installed.

On some models the separate automatic switch for each of engines of window regulators in addition to the safety lock or the automatic switch protecting all chain is installed. It protects system from that one failed window regulator did not block work of all system.

Window regulators work only when a key in the lock of ignition turn in the situation On. Also, at inclusion, the blocking switch on the main block of switches can block switches on all doors of the car, including a forward door of the passenger. Always check a condition of this switch before diagnostics of system.

The operations on diagnostics available to the simple motorist are very superficial therefore if you cannot find a malfunction source, address to experts.

Table of connection of a tester and conductivity of the main block of switches of window regulators


The table of connection of a tester and conductivity of the switch of a window regulator on a car door


Check

PERFORMANCE ORDER
1. If window regulators do not work, check a safety lock or the automatic switch.
2. If only back window regulators or if window regulators obey only the main block of switches do not work, check the blocking switch of back window regulators for conductivity of current in the switched-off situation (see the tab. The table of connection of a tester and conductivity of the switch of a window regulator on a car door). Replace it if he does not carry out current.
3. Check wires between switches and the panel of safety locks for integrity. Restore connection if there was a gap.
4. If only one window regulator does not obey the main block of switches, try to lower or lift this glass by means of the switch installed on a door. The exception makes a window regulator of a door of the driver.
5. If this window regulator obeys the door switch and does not obey the main block of switches, check the switch for conductivity (see the tab. Table of connection of a tester and conductivity of the main block of switches of window regulators).
6. If the switch as it should be, check wires between this switch and the engine of a window regulator for existence of short circuit or a gap.
7. If the window regulator does not obey both switches, remove the panel of finishing of a door on which this window regulator is established and check presence of tension on the electric motor at turning on of the switch.
8. If on the engine there is tension, disconnect glass from the regulator. Lift or lower glass a hand and check, whether it is bent or damaged. Also, check, whether will bend or the window regulator is damaged. If the window regulator is not damaged and glass goes up and down it is light, replace the engine. If glass or a window regulator are damaged or deformed, grease, replace or repair faulty details.
9. If on the engine there is no tension, check wires between switches and engines for integrity. You should look at schemes of electric equipment of the car. Electric chains of some window regulators are protected by the relay. If they are available, check that they were reliably grounded, and to them tension from switches arrived. Also, check that each relay sent tension to the engine at turning on of the switch. If is not present, replace the relay.
10. Check work of window regulators upon completion of work.