Toyota Corolla + 1. Maintenance instruction + 2. Maintenance + 3. Engines + 4. Cooling systems, heating + 5. Fuel, exhaust systems + 6. System of decrease in toxicity + 7. Transmissions + 8. Coupling and half shafts + 9. Brake system + 10. Suspension bracket and steering + 11. Body - 12. Electric equipment 12.1. Safety locks 12.2. The burned-through crossing points 12.3. Automatic switches 12.4. Relay 12.5. Breakers of indexes of turns / alarm system 12.6. The combined switch 12.7. The switches installed on a steering column 12.8. Lock of ignition and drum of the lock 12.9. Switch of a heater of back glass 12.10. Heater of back glass 12.11. Radio receiver and loudspeakers 12.12. Antenna 12.13. Bulbs of headlights of head light 12.14. Headlights of head light 12.15. Replacement of bulbs 12.16. System of day inclusion of headlights 12.17. Engine of screen wipers 12.18. Instrument guard 12.19. Sound signal 12.20. System cruise control 12.21. System of the central lock 12.22. System of window regulators 12.23. Rear-view mirrors with the electric drive 12.24. Safety airbag + 12.25. Electroschemes
|
Prevention
On these models the safety airbag is installed. The airbag of safety can reveal (to be filled with air) at any time when it is connected to the accumulator. In order that it incidentally did not reveal (and did not put a trauma), turn a key in the ignition lock in the situation LOCK and disconnect a wire of the negative plug of the accumulator before work with a safety cushion. After an accumulator detachment, wait at least two minutes before work (the module of a safety cushion has the condenser block which has to be discharged completely). For more information see subsection 12.24.
If the stereoplayer of your car has system of the coding, check, whether you know a code of activation of the player before an accumulator detachment.
Check
PERFORMANCE ORDER |
1. The breaker of indexes of turns / the alarm system, the small rectangular element located on the central block of safety locks serves for faltering work of bulbs of indexes of turns. |
2. When the breaker works normally, you have to hear rather loud clicks during its work. If indexes of turns do not work at one of the parties of the car and the breaker does not publish characteristic clicks, so one of bulbs fused |
3. If breakers of turns do not work at both parties of the car, so obviously, the safety lock fused, the breaker failed, the switch is broken or in a chain somewhere there is a bad connection. If when checking the block of safety locks, you find out that the safety lock of indexes of turns fused, check an electric chain for existence of short circuit before installation of a new safety lock. |
|
Replacement
PERFORMANCE ORDER |
1. For replacement of the breaker, simply get it from the block of safety locks. |
2. Check that the new breaker was just the same model and type, as well as old. Compare them among themselves before installation of the new breaker. |
3. Installation is carried out upside-down removals. |
|
|
|