Toyota Corolla

1992-1998 of release

Repair and operation of the car



Toyota Corolla
+ 1. Maintenance instruction
- 2. Maintenance
   2.1. Specifications
   2.2. Arrangement of knots and details
   2.3. Check of level of liquids
   2.4. Check of a condition of tires and pressure in tires
   + 2.5. Servicing through each 5000 km or 3 months
   + 2.6. Servicing through each 12000 km or 6 months
   + 2.7. Servicing through each 24000 km or 12 months
   - 2.8. Servicing through each 50000 km or 2 years
      2.8.1. Replacement of the fuel filter
      2.8.2. Check of a state and replacement of spark plugs
      2.8.3. High-voltage wires, cover of the distributor and runner of a rotor
      2.8.4. Service of the cooling system
      2.8.5. Check of system of catching of vapors of gasoline
      2.8.6. Check of an exhaust system
      2.8.7. Replacement of oil, transmission liquid and filter
      2.8.8. Replacement of oil in a manual transmission case
      2.8.9. Zolotnik and hose of system of compulsory ventilation of a case
   + 2.9. Servicing through each 100000 km or 4 years
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment


2.8.7. Replacement of oil, transmission liquid and filter

PERFORMANCE ORDER
1. Oil in a case of differential and transmission liquid are subject to periodic replacement.
2. Previously get transmission liquid (see subsection 2.1).
3. For performance of work also supports are necessary for the car, wrenches, the pallet with a volume not less than 2,5 l, newspapers and pure rags.
4. Liquid should be merged at once after a trip as with hot liquid pollution by foreign components best of all are removed.

Prevention

Temperature of transmission liquid can reach 175 °C therefore work in gloves.


5. Right after a trip with the purpose to warm up liquid lift the car and establish on supports to provide access to drain traffic jams of transmission and differential.
6. Place all necessary tools and accessories under the car, trying not to concern hot details.
7. Substitute the pallet under a drain stopper of transmission and turn off a stopper a six-sided key. Before removal of a stopper be convinced that the pallet is installed strictly under a stopper as liquid will start following under a pressure. After running off of liquid wrap a stopper and tighten.
8. Weaken at first forward bolts of fastening of the pallet of transmission then back.
9. Hook the pallet a screw-driver and merge the liquid rest. After running off of liquid turn off bolts completely and lower the pallet.
10. Turn off bolts of fastening of the filter, disconnect a bracket (is available on part of cars). When lowering the filter be careful as it contains the liquid rest. Pay attention to the stuck magnet (it is specified by an arrow). Surely clear a magnet and install in the transmission pallet.
11. Put the new filter, attach a bracket and wrap bolts. Tighten bolts with the set moment (see subsection 2.1).
12. Carefully clear laying of the pallet of laying material. Remove magnets, having remembered their arrangement, wash out the pallet and magnets in pure solvent and dry compressed air. Surely clear magnets and install in the transmission pallet.
13. Lay new laying on the pallet, install the pallet and wrap bolts in a former order. Tighten bolts with the set moment (see subsection 2.1).
14. Find a drain stopper of a case of differential. Substitute the pallet under a stopper, turn off a stopper a six-sided key and merge oil. After oil running off densely tighten a stopper.
15. During removal of a stopper be careful as oil will start following under a pressure.
16. Fill in in differential fresh liquid (see subsection 2.1). Fill in liquid to bottom edge of an opening (see subsection 2.5.1.2).

Prevention

Not to pour liquid. The automatic transmissiiya and differential are separate units.


17. Lower the car.
18. On the stopped engine add transmission liquid through a tube of the index of level. Fill in liquid through a funnel in the small portions, constantly checking level the probe (see subsection 2.5.1.2). Check level having waited for time necessary for running off of liquid in a transmission case.
19. Start the engine and transfer the selector lever from situation P to situation L, then again to situation P, put the car on the emergency brake.
20. Idling check the level of transmission liquid. Add to Cool mark in the probe.