Toyota Corolla

1992-1998 of release

Repair and operation of the car



Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Petrol engines
   - 3.2. Diesel engine
      3.2.1. Specifications
      3.2.2. Replacement of a gear belt
      3.2.3. Removal of a head of cylinders
      3.2.4. Dismantling of a head of cylinders
      3.2.5. Partition of a head of cylinders
      3.2.6. Assembly of a head of the block of cylinders
      3.2.7. Installation of a head of cylinders
      3.2.8. Check and adjustment of gaps of valves
      3.2.9. Check of a compression of cylinders
      3.2.10. Pistons and rods
      3.2.11. Measurement of cylinders
      3.2.12. Assembly of pistons and rods
      3.2.13. Installation of pistons and rods
      3.2.14. Cranked shaft and flywheel
      + 3.2.15. Cooling system
      + 3.2.16. Lubrication system
      3.2.17. Device of injection of diesel fuel
      3.2.18. Operation of the car on diesel fuel
      3.2.19. Fuel filter
      3.2.20. Fuel pump of a high pressure
      3.2.21. Nozzles
      3.2.22. Glow plugs
      3.2.23. Adjustment of the mode of idling
      3.2.24. Adjustment of the maximum turns
      + 3.2.25. Useful tips to owners of the diesel engine
   + 3.3. Electric equipment of the engine
+ 4. Cooling systems, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment


3.2.17. Device of injection of diesel fuel

GENERAL INFORMATION

Purity is an indispensable condition of carrying out all works on the diesel engine. Surely clear cap nuts of the pressure head pipeline to their otvorachivaniye. The fuel pump of a high pressure is not subject to dismantling or repair, and at refusal is replaced. Adjustment of the fuel pump of a high pressure requires the special tool and adaptations and adjustment should be made in a workshop. Diesel engines work either with direct, or with direct injection that is when fuel is injected in a forkamer in a head of cylinders which is connected with actually combustion chamber. Process of combustion begins in a forkamer and under the arising pressure of a particle of fuel are fond in the combustion chamber where there is their full combustion.

Precautionary measures during the works with the injection device

When carrying out any repair work with the injection device, irrespective of their volume, observe purity. Especially it is necessary to consider the next moments:

All works with the device of injection have to be performed in the conditions of absolute purity. Works on the street should be performed only in windless days to avoid dust hit.

Before an otvorachivaniye of their cap nuts it is necessary to wipe carefully a rag.

Put all removed details on a pure workbench and cover with paper or a film. Do not cover a detail with rags with pile. If repair is not made at once, all open or partially sorted details of the device of injection have to be covered or be stored in the closed boxes respectively.

Before installation of details check their purity.

At the opened device do not use compressed air for a purge of details of the engine.

Whenever possible do not move the car at the removed injection device details.

Do not allow hit of diesel fuel on hoses. If it occurs, at once wipe hoses. The hoses damaged from hit on them diesel fuel have to be replaced surely.