Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
- 4. Cooling systems, heating
4.1. Specifications
4.2. Antifreeze
4.3. Thermostat
4.4. Fan and relay of turning on of the fan
4.5. Radiator and broad tank
4.6. Pump of cooling liquid
4.7. Sensor of temperature of cooling liquid
4.8. Fan block
4.9. Heater radiator
+ 4.10. Control panel heater and conditioner
4.11. Vlagootodelitel of the conditioner
4.12. Compressor
4.13. Condenser
4.14. Evaporator and broad valve
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment
|
Details which should be removed at dismantle of the evaporator
|
1. Glove box
2. Air duct
|
3. Overlay of powder of a forward door
4. Cooling block |
Removal of the evaporator
|
1. Amplifier of the conditioner and interconnection
2. Block of resistors of the fan
3. Thermoresistor
4. Lower half of the case
|
5. Broad valve
6. Drain tube
7. Tubes of a supply and removal of coolant
8. Evaporator
9. Top half of the case |
Removal
| PERFORMANCE ORDER |
| 1. Depressurize the conditioner and remove coolant in service of Toyota car service or in a specialized workshop. |
|
2. Remove a glove box assembled. Disconnect conditioner tubes on a partition of a motor compartment. Turn off the union, holding a key reciprocal part not to curtail a tube. Muffle the disconnected tubes to avoid moisture hit. |
| 3. Turn off two nuts and three bolts of fastening of the evaporator to a partition of a motor compartment, remove the evaporator from the car. |
| 4. Install the evaporator on a table, unscrew screws, remove latches, remove the top and lower half of the case of the evaporator and get the evaporator. |
| 5. Get the thermoresistor from the evaporator, turn off bolts of fastening of the broad valve and two short tubes of giving and removal of coolant (see rice. Removal of the evaporator). |
|
6. Clear the evaporator a special comb and blow compressed air. Pick up a comb with distance between teeth, sootvetstuyushchy to an evaporator fins step. |
|
Installation
| PERFORMANCE ORDER |
| 1. If the new evaporator is installed, enter about 1 g of the fresh oil recommended for your conditioner. |
| 2. Further installation is carried out upside-down. Replace a sealing ring and laying of the broad valve. |
| 3. Fill the conditioner with coolant in the same workshop in which depressurization and removal of coolant were carried out. |
|
|
|