Toyota Corolla

1992-1998 of release

Repair and operation of the car



Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
- 4. Cooling systems, heating
   4.1. Specifications
   4.2. Antifreeze
   4.3. Thermostat
   4.4. Fan and relay of turning on of the fan
   4.5. Radiator and broad tank
   4.6. Pump of cooling liquid
   4.7. Sensor of temperature of cooling liquid
   4.8. Fan block
   4.9. Heater radiator
   + 4.10. Control panel heater and conditioner
   4.11. Vlagootodelitel of the conditioner
   4.12. Compressor
   4.13. Condenser
   4.14. Evaporator and broad valve
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment


4.8. Fan block

Check

PERFORMANCE ORDER
1. The block of the fan is located in salon, over the right niche for feet. If the fan does not turn on, check reliability and purity of all connections, and also serviceability of a safety lock. Be convinced that the battery is completely charged.
2. Remove a slip, a door of a glove box and the right lower panel (see subsection 1.5.44).
3. If the fan electric motor does not work, disconnect the socket from the electric motor, turn the ignition key in the situation ON (not to start the engine) whether and check there is tension on contact of a black wire when the switch of the fan is in the situation ON. If tension is absent, the power-supply circuit of system of ignition is faulty.
4. If tension from the battery is, connect the socket to the fan and concern a black-and-white wire (from a reverse side of the socket) the crossing point connected to weight. If the electric motor is not started, probable malfunction of the electric motor is a cause of failure.
5. Disconnect the socket (it is specified by an arrow). Connect electric motor conclusions through a fusible insert to the battery and with a weight. If the electric motor is not started, replace the electric motor.
6. If the electric motor is serviceable, but does not work at any speed of rotation, the switch on the control panel the heater / conditioner is faulty. Remove the control panel (see subsection 11.25) and check integrity of a chain of the switch at each position of the switch.
7. If the electric motor works only at great speed rotations, check serviceability of the block of additional resistors of the electric motor of the fan which is located under the dashboard from the passenger's seat. The place of installation of the block of resistors of the electric motor of the fan is specified by an arrow. Fastens two screws.

Removal

PERFORMANCE ORDER
1. Disconnect the socket from the block of additional resistors of the electric motor of the fan. Unscrew screws and get the block of resistors from the case.
2. Check a tester integrity of a chain of the block of resistors. On all conclusions of the block of resistors the tester has to show the closed chain. Otherwise replace the block of resistors.
3. If it is necessary to replace the electric motor, remove the holder of the socket of conducting of the fan, unscrew three screws and get the fan assembled with the electric motor and a krylchatka from the case. Krylchatka can be removed and rearranged on the new electric motor.
4. Installation is carried out upside-down.