Toyota Corolla

1992-1998 of release

Repair and operation of the car



Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
- 7. Transmissions
   + 7.1. Mechanical transmission
   - 7.2. Automatic transmission
      7.2.1. Specifications
      7.2.2. Diagnostics
      7.2.3. Replacement of epiploons
      7.2.4. Rope of a butterfly valve
      7.2.5. The switching rope
      7.2.6. The switch blocking inclusion of a starter by the included transfer
      7.2.7. Fastening of a transmission
      7.2.8. Removal and installation of a transmission
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment


7.2.6. The switch blocking inclusion of a starter by the included transfer

Adjustment

PERFORMANCE ORDER
1. If the engine is started when the lever of gear shifting is in the provision of any of transfers, except parking or neutral, the switch blocking inclusion of a starter needs to be adjusted.
2. Put the car on the emergency brake and block back wheels. Lift forward part of the car and install it on support. Include neutral transfer.
3. Disconnect the connection socket from the switch and turn off bolts of fastening of the switch.
4. Connect ohmmeter probes to switch plugs on the socket of connection and rotate the switch until the ohmmeter shows short circuits of a chain that testifies that it is in the provision of neutral transfer. Then twirl fixing bolts.

Replacement

PERFORMANCE ORDER
1. Disconnect a wire of the negative plug of the accumulator.

Prevention

If the stereoplayer of your car has system of the coding, check, whether you know a code of activation of the player before an accumulator detachment.


2. Include neutral transfer.
3. Turn off a nut and remove the switching lever.
4. Disconnect the connection socket.
5. By means of a screw-driver, unbend a uvula on an engraving washer under the nut fixing the switch to a valve axis.
6. Turn off an engraving nut and remove an engraving washer and simple washers.
7. Turn off fixing bolts and remove the switch from an axis.
8. For installation of the switch, combine edges of an axis with edges of cut in the switch and put on it an axis. Establish simple washers, an engraving washer and a fixing nut. Tighten a fixing nut and bend a uvula of a washer of the Engraver.

9. Turn the switch so that the line of neutral situation (1) was combined with a flute (2). Then twirl bolts and connect the connection socket.
10. Install the switching lever, connect a wire of the negative plug of the accumulator and check that the engine was not started if any of transfers, except neutral and parking is included. If it is necessary, carry out adjustment which procedure is described above.