+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
- 12. Electric equipment
12.1. Safety locks
12.2. The burned-through crossing points
12.3. Automatic switches
12.5. Breakers of indexes of turns / alarm system
12.6. The combined switch
12.7. The switches installed on a steering column
12.8. Lock of ignition and drum of the lock
12.9. Switch of a heater of back glass
12.10. Heater of back glass
12.11. Radio receiver and loudspeakers
12.13. Bulbs of headlights of head light
12.14. Headlights of head light
12.15. Replacement of bulbs
12.16. System of day inclusion of headlights
12.17. Engine of screen wipers
12.18. Instrument guard
12.19. Sound signal
12.20. System cruise control
12.21. System of the central lock
12.22. System of window regulators
12.23. Rear-view mirrors with the electric drive
12.24. Safety airbag
+ 12.25. Electroschemes
On these models the airbag of safety which can reveal (it will be filled with air) when it is connected to the accumulator is installed. Disconnect a wire of the negative plug of the accumulator and wait at least two minutes before work with the safety airbag.
If the stereoplayer of your car has system of the coding, check, whether you know a code of activation of the player before an accumulator detachment.
Elements of a screen wiper of back glass
1. Screen wiper lever
2. Screen wiper engine
3. Panel of finishing of a back door
The engine of screen wipers of a windshield is located on the right side (the party of the passenger) under a cowl on a back wall of a motive compartment, and the engine of a screen wiper of back glass is located on a back door.
| PERFORMANCE ORDER
|Switch of washers / screen wipers of a windshield
| 1. When checking the switch of washers / screen wipers of a windshield, be guided by instructions (see subsection 12.7).
|Engine of screen wipers
|2. If the engine of screen wipers does not work, properly or does not return a brush in the lower situation at switching off, and check of the switch showed that it as it should be, it is necessary to replace the relay of the engine or the engine.
| PERFORMANCE ORDER
|Engine of screen wipers of a windshield
| 1. Disconnect a wire of the negative plug of the accumulator.
||2. Disconnect the socket of connection of engines of screen wipers (And), turn off bolts and a fixing bolt of an arm of the engine (are specified by shooters), then lower the engine together with an arm and remove it from the car.
| 3. Installation is carried out upside-down removals.
|Engine of a screen wiper of back glass
|4. Remove the screen wiper lever, then turn off and remove nuts and washers from a lever axis.
|5. Disconnect the connection socket, disconnect the connecting mechanism, turn off fixing bolts and remove the engine through an opening of a back door.
|6. Installation is carried out upside-down removals.