Toyota Corolla

1992-1998 of release

Repair and operation of the car



Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
- 8. Coupling and half shafts
   8.1. Specifications
   - 8.2. Coupling
      8.2.1. Coupling elements
      8.2.2. Vyzhimna bearing and fork of switching off of coupling
      8.2.3. Main cylinder of the drive of switching off of coupling
      8.2.4. Working cylinder of the drive of switching off of coupling
      8.2.5. Hydraulic system of the drive of switching off of coupling
      8.2.6. The switch blocking start of the engine
   + 8.3. Half shaft
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment



8.2.4. Working cylinder of the drive of switching off of coupling

GENERAL INFORMATION

Elements of the working cylinder of the drive of switching off of coupling

1. Working cylinder

2. Spring

3. Piston

4. Pusher

5. Cover

Prevention

Before work, learn, how much is already restored or new cylinder, and whether there are they on sale. Depending on it, you will make the decision, whether you should most be engaged in restoration of the cylinder. If you decide to restore the cylinder, check its internal surface before purchase of spare parts in the beginning.


Removal

PERFORMANCE ORDER
1. Disconnect a wire of the negative plug of the accumulator.

Prevention

If the stereoplayer of your car has system of the coding, check, whether you know a code of activation of the player before an accumulator detachment.


2. Lift the car and install it on support.
3. Disconnect a hydraulic tube of the working cylinder. If is available, use a cap wrench for connection untwisting not to break a side (it is specified by the left arrow). Then turn off two fixing bolts (are specified by the right shooters). Prepare some rags as at a detachment of a tube can spill a little hydraulic liquid.
4. Turn off fixing bolts of the working cylinder.
5. Remove the working cylinder.

Partition

PERFORMANCE ORDER
1. Remove a pusher and a cover (see rice. Elements of the working cylinder of the drive of switching off of coupling).
2. Knock with the cylinder on a wooden surface to get the piston and consolidation. Take a spring from a cylinder cavity.
3. Carefully examine an internal surface of the cylinder on existence of deep scratches or notches. The surface to the touch has to be smooth. If it not ideally smooth, the working cylinder needs to be replaced.
4. Using new details from a repair kit, collect the cylinder, plentifully greasing all elements before assembly by fresh brake fluid. Check correctness of installation of a spring and consolidation.

Installation

PERFORMANCE ORDER
1. Install the working cylinder of the drive of switching off of coupling on a coupling case. Check that the pusher got to a nest of a vyzhimny fork.
2. Connect a hydraulic tube to the working cylinder. Tighten connection.
3. Fill in in a tank of the main cylinder of the drive of switching off of coupling fresh hydraulic liquid of the demanded type (see subsection 2.1).
4. Pump over hydraulic system (see subsection 8.2.5).
5. Lower the car and connect a wire of the negative plug of the accumulator.