Toyota Corolla

1992-1998 of release

Repair and operation of the car



Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
- 8. Coupling and half shafts
   8.1. Specifications
   - 8.2. Coupling
      8.2.1. Coupling elements
      8.2.2. Vyzhimna bearing and fork of switching off of coupling
      8.2.3. Main cylinder of the drive of switching off of coupling
      8.2.4. Working cylinder of the drive of switching off of coupling
      8.2.5. Hydraulic system of the drive of switching off of coupling
      8.2.6. The switch blocking start of the engine
   + 8.3. Half shaft
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment


8.2.2. Vyzhimna bearing and fork of switching off of coupling

GENERAL INFORMATION

Prevention

The asbestine dust forming as a result of wear frictional swore at couplings, and postponing on coupling elements, is hazardous to health – do not inhale it.


Removal and check

PERFORMANCE ORDER
1. Disconnect a wire of the negative plug of the accumulator.

Prevention

If the stereoplayer of your car has system of the coding, check, whether you know a code of activation of the player before an accumulator detachment.


2. Remove a transmission (see subsection 7.1.5 and subsection 7.2.8).
3. Remove a fork of switching off of coupling from an axis with a spherical head, then remove vyzhimny the bearing from a fork.

4. Take the bearing for an external path of swing and rotate an internal holder, having pressured her. If the bearing does not rotate easily or works with noise, replace it. Wipe the bearing a pure rag and examine it on existence of damages, cracks or wear tracks.
5. Do not immerse the bearing in solvent – for its sealing sealant was used and if to lower the bearing in solvent, sealant will be dissolved, and the bearing will fail. Also, check a fork of switching off of coupling for existence of cracks and deformation.

Installation

PERFORMANCE ORDER
1. Fill an internal flute of the vyzhimny bearing with high-temperature greasing. Also, apply a thin film of the same greasing on vents of an entrance shaft of a transmission and an installation site of the bearing.
2. Grease a nest of a fork of switching off of coupling in which the spherical head of an axis of a fork, the ends of a fork and the end of a rod of the working cylinder is established by high-temperature greasing.
3. Install vyzhimny the bearing in a coupling switching off fork nest.
4. Put on vyzhimny the bearing an entrance shaft of a transmission, having inserted a fork of switching off of coupling into a coupling case opening. Establish a fork on an axis with a spherical head.
5. Apply a thin film of high-temperature greasing on a surface of the vyzhimny bearing in that place where it concerns plates of a diaphragm spring of a press disk.
6. Further installation is carried out upside-down removals.