1992-1998 of release
Repair and operation of the car
+ 1. Maintenance instruction
- 2. Maintenance
2.2. Arrangement of knots and details
2.3. Check of level of liquids
2.4. Check of a condition of tires and pressure in tires
+ 2.5. Servicing through each 5000 km or 3 months
+ 2.6. Servicing through each 12000 km or 6 months
+ 2.7. Servicing through each 24000 km or 12 months
+ 2.8. Servicing through each 50000 km or 2 years
+ 2.9. Servicing through each 100000 km or 4 years
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment
In this manual the term "maintenance" belongs to set of the performed works, but not to concrete procedure.
If from the moment of acquisition of the new car in accuracy to observe a maintenance order, to carry out frequent inspections of level of liquids and details subject to the increased wear of what it is insistently reminded in the management, at the engine high operational qualities and volume of additional works will remain will be minimized.
However, if to carry out maintenance irregularly, operation of the engine, most likely, will be unsatisfactory. Especially it concerns the engine of the acquired not new car which was not exposed to regular checks. In such cases besides periodic maintenance, it is necessary to perform additional adjustment works.
Any kind of works on maintenance, or search of the reason of abnormal operation of the engine should be begun with check of a compression in cylinders. Check of a compression in cylinders (see subsection 184.108.40.206) gives valuable information of rather general condition of many details of the internal device of the engine which can be used as fundamental both for the current maintenance, and for repair procedures. If, for example, a compression such is that strong wear of the engine is obvious, routine maintenance will not lead to restoration of normal operational qualities and all works will be reduced to an excessive waste of time and money.
The list of works which performance often leads to restoration of normal operation of the engine is given below.
Minor adjustment works
Clear, examine and check the battery (see subsection 2.6.3).
Check a state and level of all liquids of the engine (see subsection 2.5.1 and subsection 2.3).
Check and adjust drive belts (see subsection 2.6.4).
Replace spark plugs (see subsection 2.8.2).
Check a cover and the runner of the distributor of ignition (see subsection 2.8.3).
Check candles and wires of a high voltage of the coil of ignition (see subsection 3.3.4).
Check all hoses in a motor compartment (see subsection 2.6.5).
Check the cooling system (see subsection 2.6.6).
Check the air filter (see subsection 2.7.2).
Main adjustment works
All minor works and what are listed below:
Check system of ignition (see subsection 3.3.4).
Check system of a charge of the battery (see subsection 2.6.3).
Check fuel system (see subsection 2.7.3).
Replace the air filter (see subsection 2.7.2).
Replace a cover and the runner of the distributor of ignition (see subsection 2.8.3).
Replace high-voltage wires (see subsection 2.8.3).