Toyota Corolla

1992-1998 of release

Repair and operation of the car

Toyota Corolla
+ 1. Maintenance instruction
- 2. Maintenance
   2.1. Specifications
   2.2. Arrangement of knots and details
   2.3. Check of level of liquids
   2.4. Check of a condition of tires and pressure in tires
   + 2.5. Servicing through each 5000 km or 3 months
   + 2.6. Servicing through each 12000 km or 6 months
   + 2.7. Servicing through each 24000 km or 12 months
   - 2.8. Servicing through each 50000 km or 2 years
      2.8.1. Replacement of the fuel filter
      2.8.2. Check of a state and replacement of spark plugs
      2.8.3. High-voltage wires, cover of the distributor and runner of a rotor
      2.8.4. Service of the cooling system
      2.8.5. Check of system of catching of vapors of gasoline
      2.8.6. Check of an exhaust system
      2.8.7. Replacement of oil, transmission liquid and filter
      2.8.8. Replacement of oil in a manual transmission case
      2.8.9. Zolotnik and hose of system of compulsory ventilation of a case
   + 2.9. Servicing through each 100000 km or 4 years
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment

2.8. Servicing through each 50000 km or 2 years

2.8.1. Replacement of the fuel filter

PERFORMANCE ORDER

1. Disconnect the battery from weight (at first be convinced that to you the code of a raskodirovka of the radio tape recorder is known if the last is equipped with the blocking device in case of plunder).
2. The fuel filter is attached to an arm on a partition of a motor compartment on the left side of the car.
3. For access to the top part of the filter remove all necessary details.
	4. Fix a key the filter from a provorachivaniye and turn off a bolt of the cap "banjo" union in the top part of the filter.
	5. Then unscrew the union in the lower part of the filter (working at opportunity with an adjustable spanner).
6. Turn off both bolts of fastening of an arm to a partition of a motor compartment and get the fulfilled filter assembled with an arm.
7. Remember a filter arrangement, put accurate tags on entrance and final channels of the filter, pay attention that the filter has to be turned by expanded part down. At installation orient the new filter so that its situation in accuracy coincided with position of the replaced filter.
8. Replace sealing disposable washers from a set of the new filter and turn inlet and final the union, reliably tighten.
9. Further installation is carried out upside-down.