Toyota Corolla

1992-1998 of release

Repair and operation of the car



Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
- 5. Fuel, exhaust systems
   5.1. Specifications
   5.2. Order of performance of a decompression of fuel system
   5.3. Fuel pump and pressure of fuel
   5.4. Removal and installation of the fuel pump
   5.5. Fuel level sensor
   5.6. Fuel pipes and joints
   5.7. Fuel tank
   5.8. Cleaning and repair of a fuel tank
   5.9. Air filter
   5.10. Cable of the drive of a butterfly valve
   5.11. System of electronic injection of fuel (EFI - system)
   5.12. Check and replacement of EFI units - systems
   5.13. Service of an exhaust system
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment



5.6. Fuel pipes and joints

GENERAL INFORMATION

Sometime there will come time and you should check a condition of an exhaust system or to change some details (for example, suspension brackets of exhaust pipes) for what it is required to lift the car. When performing any works under the car always check a condition of fuel pipes, all joints and connections.

Check

PERFORMANCE ORDER
1. Check existence on hoses and tubes of cracks, breaks, deformations.
2. Be convinced of reliability of fastening of fuel pipes to the body bottom, check a condition of fixing brackets.
3. Check tightness of connections of hoses with unions of metal tubes, a condition of collars of hoses.

Replacement

PERFORMANCE ORDER
1. New details of the fuel highway have to be made of the same material, as the replaced details. It is forbidden to establish hoses and tubes from materials, not corresponding recommended, or not calculated on fuel influence. Otherwise leak of fuel and creation of a fire-dangerous situation is possible.
2. Always before dismantling of the fuel highway, or a detachment of any detail, mark a relative positioning of tubes (1) and hoses (2), remember initial installation of collars (3) and forelocks that at assembly in accuracy to restore an initial arrangement of these details. Observe the scheme and an order of fastening of hoses on unions of metal tubes.
3. Before dismantling of a fuel pipe execute actions for a decompression of the highway of fuel system, turn off a stopper of a jellied mouth of a tank and disconnect the battery from weight. Wrap up the investigated connection by rags for absorption of the spilled gasoline.








Thomson 14MA10C