Toyota Corolla

1992-1998 of release

Repair and operation of the car



Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Suspension bracket and steering
- 11. Body
   11.1. Maintenance and repair
   11.2. Vinyl finishing
   11.3. Upholstery and rugs
   11.4. Repair of insignificant damages of a body
   11.5. Repair of considerable damages of a body
   11.6. Loops and locks
   11.7. Windshield and motionless glasses
   11.8. Cowl
   11.9. Trunk lid
   11.10. A back door (models with a body "Station wagon")
   11.11. Basic rack of a back door
   11.12. Decorative panel of a door
   11.13. Door
   11.14. Door latch, cylinder of the lock and handle
   11.15. Door windowpane
   11.16. Bumpers
   11.17. External mirror
   11.18. Seats
   11.19. Frame of a combination of devices
   11.20. Glove compartment
   11.21. Central decorative panel
   11.22. Casing of a steering column
   11.23. Lower panel of finishing of a steering column
   11.24. Console
   11.25. Dashboard
   11.26. Front grille
   11.27. Ventilating grate of a cowl
   11.28. Seat belts
+ 12. Electric equipment


11.19. Frame of a combination of devices

GENERAL INFORMATION

Prevention

These models are equipped with safety airbags. The safety cushion is in a ready state and can be developed (to be inflated) at any time if the accumulator is connected. To avoid casual expansion (and a possible trauma), turn the ignition key in the situation LOCK and disconnect a wire of "weight" from the accumulator every time when work about details of airbags of safety. After the accumulator is disconnected, wait, at least, two minutes before beginning work (the system has the reserve condenser which has to be discharged completely). For obtaining more detailed information (see subsection 12.24).


Removal and installation

PERFORMANCE ORDER
1. Disconnect a wire of "weight" from the accumulator.
2. Unscrew two bolts on the top part of a frame.
3. Disconnect two clips at bottom edges, having raised them by means of a screw-driver
4. Strong clamp a frame and remove it
5. Installation is made in the return sequence.