Toyota Corolla

1992-1998 of release

Repair and operation of the car



Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Suspension bracket and steering
- 11. Body
   11.1. Maintenance and repair
   11.2. Vinyl finishing
   11.3. Upholstery and rugs
   11.4. Repair of insignificant damages of a body
   11.5. Repair of considerable damages of a body
   11.6. Loops and locks
   11.7. Windshield and motionless glasses
   11.8. Cowl
   11.9. Trunk lid
   11.10. A back door (models with a body "Station wagon")
   11.11. Basic rack of a back door
   11.12. Decorative panel of a door
   11.13. Door
   11.14. Door latch, cylinder of the lock and handle
   11.15. Door windowpane
   11.16. Bumpers
   11.17. External mirror
   11.18. Seats
   11.19. Frame of a combination of devices
   11.20. Glove compartment
   11.21. Central decorative panel
   11.22. Casing of a steering column
   11.23. Lower panel of finishing of a steering column
   11.24. Console
   11.25. Dashboard
   11.26. Front grille
   11.27. Ventilating grate of a cowl
   11.28. Seat belts
+ 12. Electric equipment



11.14. Door latch, cylinder of the lock and handle

GENERAL INFORMATION

Remove the decorative panel of a door and the plastic guard protecting a door from moisture hit (see subsection 11.12).

DOOR LATCH

Removal and installation

PERFORMANCE ORDER
1. Behind the panel of a door disconnect the operating drafts from a latch.
2. Unscrew fixing bolts of a latch from a door end face.
3. Disconnect a latch of a door and the solenoid of the door lock (if it is installed).
4. Installation is made in the return sequence.

CYLINDER OF THE LOCK AND EXTERNAL HANDLE

Removal and installation

PERFORMANCE ORDER
1. Disconnect the operating draft from the cylinder of the lock and the external handle.
2. Unscrew the bolts fixing the external handle and take the handle and the cylinder of the lock from a door. Access to bolts – can be received through an opening for access in a door frame.
3. Use a screw-driver to unfasten a clip and to remove the cylinder from a door.
4. Installation is made in the return sequence.

INTERNAL HANDLE

Removal and installation

PERFORMANCE ORDER
1. Unscrew a fixing bolt of the internal handle.
2. Unscrew the handle to get access to draft.
3. Slightly pull for the handle, by means of a small screw-driver, disconnect draft from the control unit of the internal handle and remove it from a door.
4. Installation is made in the return sequence.