Toyota Corolla
- 1. Maintenance instruction
1.2. Codes of models
1.3. Control panel
+ 1.4. Combination of devices
+ 1.5. Governing bodies and instrumentations
+ 1.6. Start-up of the engine and driving
1.7. Specifications
1.8. Adjusting data, filling capacities and liquids
- 1.9. Possible malfunctions
1.9.1. Start of the engine in extreme conditions
1.9.2. Replacement of a wheel
1.9.3. Detection of a place of a leak
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment
|
Some features of installation of a wheel can differ depending on car model. For example, locations of a spare wheel and a jack on cars of various models differ. However the general order of works is identical to all cars.
Preparation
| PERFORMANCE ORDER |
| 1. At a wheel puncture immediately stop the car, considering traffic conditions. |
| 2. Install the car on an equal firm surface on sufficient removal from a lane. |
| 3. If necessary include a signal of an emergency stop. |
| 4. If you have a sign of an emergency stop, establish it for the prevention of other drivers. |
| 5. Put the car on the emergency brake and include the first or reverse gear (the situation Park in cars with an automatic tranmissiya). |
| 6. Block a wheel diagonalno opposite replaced, – two big stones for this purpose will approach. |
| 7. If the soil soft, in order to avoid immersion of a jack substitute under it a board. |
|
Replacement
| PERFORMANCE ORDER |
|
1. Remove the decorative panel from the inside of a luggage compartment and remove a jack. |
|
2. Lift a cover of a trunk floor and turn off the holder of a spare wheel. Get a spare wheel, a bag with tools and a key for nuts of wheels. Substitute the blocks which are included in the package of tools under a wheel diagonalno opposite to the replaced. |
|
3. Take off a decorative cap of a wheel by means of the shovel which is included in the package of tools. Then a wheel key weaken half way nuts of fastening of the replaced wheel. |
|
4. Establish a jack on the firm soil under the strengthened body threshold section (lift the car, establish a jack only under this place) |
|
5. Rotate the jack handle clockwise until the wheel is not raised over the earth, turn off nuts of fastening of a wheel and remove a wheel. |
|
6. Establish a spare wheel, turn and tighten fastening nuts. Lower the car and tighten fastening nuts in the specified sequence. |
| 7. Establish a decorative cap. |
| 8. Clean from under a block wheel. |
| 9. Put a jack and tools in a luggage carrier, observing correctness of placement. Check pressure in the tire of the established wheel. If pressure low, or you have no manometer, moving at a small speed, reach the nearest garage and pump up the tire up to the normal pressure. |
| 10. Immediately hand over the damaged wheel (or the tire) in repair. |
|
|
|