Toyota Corolla

1992-1998 of release

Repair and operation of the car



Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Petrol engines
   + 3.2. Diesel engine
   - 3.3. Electric equipment of the engine
      3.3.1. Specifications
      3.3.2. Battery
      3.3.3. Power cables
      3.3.4. System of ignition
      3.3.5. Ignition coil
      3.3.6. Ignition distributor
      3.3.7. Check and installation of the moment of ignition
      3.3.8. Block of electronic ignition
      3.3.9. Induction sensor
      3.3.10. System of a charge of the battery
      3.3.11. Generator
      3.3.12. Generator details
      3.3.13. System of start-up of the engine
      3.3.14. Starter electric motor
+ 4. Cooling systems, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment


3.3.1. Specifications

GENERAL INFORMATION

Ignition advancing corner

At the grounded conclusions of TE1 and E1
10 ° to VMT
At the conclusions of TE1 and E1 disconnected from weight:
  – for engines 4E – FE
6 – 18 ° to VMT
  – for engines 4A – FE and 7E – FE
5 – 15 ° to VMT

Ignition coil resistance

For distributors with the built-in block of electronic ignition:
  – resistance of primary winding
1,11 – 1,75 Ohms
  – resistance of a secondary winding
9,0 – 15,7 kOhm
For distributors with the external block of electronic ignition:
  – resistance of primary winding
0,36 – 0,55 Ohms
  – resistance of a secondary winding
9,0 – 15,4 kOhm

Ignition distributor

Gap between a rotor and the sensor
0,2 – 0,4 mm
Resistance of the induction sensor:
For distributors with the built-in block of electronic ignition:
  – at a temperature below 57 °C:
     • between conclusions of G-and G +
185 – 275 Ohms
     • between conclusions of NE-and NE +
370 – 550 Ohms
  – at a temperature above 58 °C:
     • between conclusions of G-and G +
240 – 325 Ohms
     • between conclusions of NE-and NE +
475 – 650 Ohms
For distributors with the external block of electronic ignition:
  – at a temperature below 57 °C:
     • between conclusions of G-and G +
185 – 275 Ohms
     • between conclusions of NE-and NE +
1,630 – 2,740 Ohms
  – at a temperature above 58 °C:
     • between conclusions of G-and G +
240 – 325 Ohms
     • between conclusions of NE-and NE +
2,065 – 3,225 Ohms

System of charging

Charging tension
13,9 – 15,1 B
Nominal rate of charging current:
  – at the switched-off devices of lighting and other consumers
no more than 10 And
  – at inclusion of a driving beam of headlights and the fan of a heater
not less than 30 And
Length of brushes of the generator:
  – new brushes
10,4 mm (13 / 32 inches)
  – the limit
1,58 mm (1 / 16th inch)