Toyota Corolla

1992-1998 of release

Repair and operation of the car



Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Petrol engines
   + 3.2. Diesel engine
   - 3.3. Electric equipment of the engine
      3.3.1. Specifications
      3.3.2. Battery
      3.3.3. Power cables
      3.3.4. System of ignition
      3.3.5. Ignition coil
      3.3.6. Ignition distributor
      3.3.7. Check and installation of the moment of ignition
      3.3.8. Block of electronic ignition
      3.3.9. Induction sensor
      3.3.10. System of a charge of the battery
      3.3.11. Generator
      3.3.12. Generator details
      3.3.13. System of start-up of the engine
      3.3.14. Starter electric motor
+ 4. Cooling systems, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment


3.3.9. Induction sensor

GENERAL INFORMATION

Check of resistance of the induction sensor of the distributor

1. An arrangement of conclusions on cars with the built-in block of electronic ignition (Toyota and GEO respectively)
2. An arrangement of conclusions on cars with the block of electronic ignition of external installation (Toyota and GEO respectively)
  3. An arrangement of conclusions on cars with the built-in block of electronic ignition (Toyota and GEO respectively)
4. An arrangement of conclusions on cars with the block of electronic ignition of external installation (Toyota and GEO respectively)

Check

PERFORMANCE ORDER
1. Disconnect the socket from the distributor and measure resistance between conclusions of the induction sensor (See a photo Check of resistance of the induction sensor of the distributor).
2. Compare results of measurements to the values specified in the section "Specifications". If the measured resistance differ from standard values, replace the sensor.

Check of a gap between the sensor and a rotor

PERFORMANCE ORDER
1. Disconnect the battery from weight.
2. Remove the distributor (see subsection 3.3.6).
3. Measure by the brass probe a gap between a rotor and a ledge of the induction sensor. Compare result to the standard. If the gap differs from standard, replace the distributor as the gap is not subject to adjustment. The increase in a gap against norm is usually caused by wear of the bearing of the distributor.

Replacement

PERFORMANCE ORDER
1. Disconnect the battery from weight.
2. Remove the distributor (see subsection 3.3.6).
3. Remove the ignition coil (see subsection 3.3.5).
4. Unscrew adjusting screws of the induction sensor.
5. Remove the induction sensor from the distributor.
6. Remove the condenser and replace it.
7. Installation is carried out upside-down.