Toyota Corolla

1992-1998 of release

Repair and operation of the car



Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and half shafts
- 9. Brake system
   9.1. Specifications
   9.2. System of anti-blocking of brakes (ABS)
   9.3. Brake shoes of forward brakes
   9.4. Support of forward brakes
   9.5. Brake shoes of back disk brakes
   9.6. Support of back disk brakes
   9.7. Brake disk
   9.8. Brake shoes of back drum brakes
   9.9. Working cylinder
   9.10. Main cylinder of brake system
   9.11. Brake hoses and tubes
   9.12. Hydraulic system of brakes
   9.13. Vacuum amplifier
   9.14. Emergency brake
   9.15. Ropes of the emergency brake
   9.16. Brake pedal
   9.17. Switch of headlights of a stoplight
   9.18. Valve of restriction of pressure sensitive to car loading
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment


 ïåðèîä áåðåìåííîñòè âàæíî è íóæíî äóìàòü î ñâîåé êðàñîòå è íîâîì îáëèêå.

9.9. Working cylinder

GENERAL INFORMATION

Prevention

If it is necessary to carry out a partition of the working cylinder (usually because of leak of brake fluid) previously learn the price of spare parts or cost of already vosstavlenny or new cylinder. Before a partition get a repair set. Always repair both working cylinders together, – never repair only one of them.


Removal

PERFORMANCE ORDER
1. Lift back part of the car and install it on support. Block lobbies a wheel that the car incidentally did not sweep.
2. Remove brake shoes of a back brake (see subsection 9.8).
3. Remove dirt round the working cylinder.
4. Disconnect a brake tube (1) by means of a cap wrench if is available. Do not pick up the phone from the cylinder. Turn off fixing bolts (2) workers of the cylinder.
5. Remove the working cylinder from a board of a back brake and establish it on a pure desktop. As soon as possible close an opening of a brake tube for prevention of loss of brake fluid and hit in a dirt tube.

Partition

PERFORMANCE ORDER
1. Remove the valve of production of air, caps, pistons, covers and springs from the cylinder (see rice. Elements of a back drum brake).
2. Wash out the working cylinder brake fluid, alcohol or the cleaning liquid for the mechanism of brakes.

Prevention

It is forbidden to use solvents on the basis of gasoline for cleaning of elements of brakes.


3. By means of clean compressed air dry up the working cylinder and blow channels.
4. Check an internal surface of the cylinder for existence of corrosion and scratches – the cylinder needs to be replaced if its internal surface is scratched or has corrosion traces.
5. Grease new caps with brake fluid.
6. Collect elements of the working cylinder. Check, that cap edges inspectors inside.

Installation

PERFORMANCE ORDER
1. Install the working cylinder on a place and fingers twirl fixing bolts. Connect a brake tube to the working cylinder. Check reliability of connection. Tighten bolts of fastening of the working cylinder till the demanded moment of an inhaling specified in the section of technical characteristics at the beginning of this chapter.
2. Reliably tighten connection of a brake tube and establish brake shoes (see subsection 9.8).
3. Pump over brake system (see subsection 9.12).
4. Check work of brakes before normal operation of the car.