Toyota Corolla

1992-1998 of release

Repair and operation of the car



Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
- 10. Suspension bracket and steering
   10.1. Specifications
   10.2. Rack of a suspension bracket (lobby)
   10.3. Suspension bracket rack
   10.4. Stabilizer of cross stability (forward suspension bracket) and plug
   10.5. Suspension bracket lever
   10.6. Spherical hinges
   10.7. Rotary fist and nave
   10.8. Nave and bearing of a nave (forward wheel)
   10.9. Stabilizer of cross stability (back suspension bracket) and plug
   10.10. Rack of a suspension bracket (back)
   10.11. Longitudinal draft
   10.12. Cross drafts of a suspension bracket
   10.13. Nave and bearing (back wheel)
   10.14. Arm of a nave of a back wheel
   10.15. Steering
   10.16. Steering wheel
   10.17. Tips of steering drafts
   10.18. Steering transfer
   10.19. Pump of system of strengthening of a steering
   10.20. System of strengthening of a steering
   10.21. Wheels and tires
   10.22. Adjustment of corners of installation of wheels
+ 11. Body
+ 12. Electric equipment



10.17. Tips of steering drafts

Removal

PERFORMANCE ORDER
1. Turn off nuts of fastening of a wheel. Lift forward part of the car, install it on support, block back wheels and put the car on the emergency brake. Remove a forward wheel.
2. Get adjustable to the check and turn off a koronchaty nut on a tip of steering draft, but do not remove it.
3. Holding a tip of steering draft by means of flat-nose pliers or a wrench, turn off a lock-nut so that it was possible to mark the provision of a tip in relation to a draft carving.
4. Disconnect steering draft from the lever of a rotary fist by means of a stripper. Turn off a nut and remove steering draft.
5. Turn off a tip of steering draft.

Installation

PERFORMANCE ORDER
1. Twirl a tip of steering draft to the mark made earlier and establish it on the lever of a rotary fist. Reliably twirl a tip lock-nut.
2. Establish a koronchaty nut on a tip of steering draft and tighten it till the demanded inhaling moment (see subsection 10.1). Insert new adjustable to the check. If the opening for adjustable checks does not coincide with cut on a nut, put the clamp a little more.
3. Establish a wheel and nuts of fastening of a wheel. Lower the car on the earth and tighten nuts of fastening of a wheel till the demanded inhaling moment (see subsection 10.1).
4. Address to experts for check and adjustment of forward wheels.