Toyota Corolla

1992-1998 of release

Repair and operation of the car



Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
- 10. Suspension bracket and steering
   10.1. Specifications
   10.2. Rack of a suspension bracket (lobby)
   10.3. Suspension bracket rack
   10.4. Stabilizer of cross stability (forward suspension bracket) and plug
   10.5. Suspension bracket lever
   10.6. Spherical hinges
   10.7. Rotary fist and nave
   10.8. Nave and bearing of a nave (forward wheel)
   10.9. Stabilizer of cross stability (back suspension bracket) and plug
   10.10. Rack of a suspension bracket (back)
   10.11. Longitudinal draft
   10.12. Cross drafts of a suspension bracket
   10.13. Nave and bearing (back wheel)
   10.14. Arm of a nave of a back wheel
   10.15. Steering
   10.16. Steering wheel
   10.17. Tips of steering drafts
   10.18. Steering transfer
   10.19. Pump of system of strengthening of a steering
   10.20. System of strengthening of a steering
   10.21. Wheels and tires
   10.22. Adjustment of corners of installation of wheels
+ 11. Body
+ 12. Electric equipment


10.20. System of strengthening of a steering

Pumping

PERFORMANCE ORDER
1. If when performing any operations, you disconnected hydraulic hoses of system of strengthening of a steering, the system needs to be pumped over to remove from it all air and to achieve the demanded strengthening of a steering.
2. Having established wheels so that they looked precisely directly, check the level of hydraulic liquid in a tank of the pump and if it is necessary, add such amount of hydraulic liquid of the recommended type (see subsection 2.1) that its level rose to Cold mark in the probe.
3. Start the engine and set aside it to work in the single mode with the raised turns. Again check the level of hydraulic liquid and add it if it is necessary in order that the level of hydraulic liquid was at the level of Cold mark in the probe.
4. Pump over system of strengthening of a steering, having turned wheels several times here and there, do not turn a wheel up to the end. It will remove air from hydraulic system. During removal of air watch that the tank of hydraulic liquid on the pump was full.
5. After air is removed from system, establish wheels so that they looked precisely directly, and leave the engine to work for some minutes before muffling it.
6. Pass on the car and check work of a steering and lack of an extraneous noise at rotation of a steering wheel.
7. Check the level of hydraulic liquid, it has to be at the level of Hot mark in the probe while the engine is heated-up up to the normal working temperature. Add hydraulic liquid if it is necessary (see subsection 2.5).