Toyota Corolla

1992-1998 of release

Repair and operation of the car



Toyota Corolla
- 1. Maintenance instruction
   1.2. Codes of models
   1.3. Control panel
   + 1.4. Combination of devices
   + 1.5. Governing bodies and instrumentations
   - 1.6. Start-up of the engine and driving
      1.6.1. Check before start-up of the engine
      1.6.2. Check after start-up of the engine
      1.6.3. Methods of driving
      + 1.6.4. Towage of the trailer
      1.6.5. Actions at refusal of start-up of the engine
      1.6.6. Obligatory set of tools and spare wheel
      1.6.7. Replacement of a wheel
      1.6.8. Towage of the car
      1.6.9. Motor compartment
      1.6.10. Arrangement of safety locks
      1.6.11. Check of level of oil in the engine
      1.6.12. Oil brand choice
      1.6.13. Check of level of cooling liquid
      1.6.14. Composition of cooling liquid
      1.6.15. Check of pressure in tires
      1.6.16. Replacement of tires
      1.6.17. Shift of wheels
      1.6.18. Installation of winter tires and chains
      1.6.19. Precautionary measures for cast aluminum disks
      1.6.20. Check of an external condition of the battery
      1.6.21. Check of level of electrolyte
      1.6.22. Battery charging
      1.6.23. Check and replacement of safety locks
      + 1.6.24. Replacement of lamps
   1.7. Specifications
   1.8. Adjusting data, filling capacities and liquids
   + 1.9. Possible malfunctions
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment



1.6.20. Check of an external condition of the battery

GENERAL INFORMATION

1. Fastening bracket

2. A soyedinayeniye cable with a weight

3. Poles


Check existence of corrosion on terminal connections, cracks or weakening of fastening.

PERFORMANCE ORDER
1. At detection of corrosion wash out the struck place water solution of baking soda. Grease plugs with jellied greasing to prevent further corrosion.
2. Tighten nuts of plugs, the excessive inhaling is not allowed.
3. Tighten a bracket of fastening of the battery, the excessive inhaling is not allowed in order to avoid damage of the case of the battery.

Prevention

Before service of the battery stop the engine and switch-off all electric devices.

When checking disconnect the battery from "weight" first of all, and connect to "weight" in the last turn.

Be careful of short circuit of the battery the tool.

Exclude hit in the solution battery for washing.